fbpx

Hydraform

M7 Stationary Interlocking Blockmaking Machine

The M7 Stationary is a cost effective option where mobility is not a requirement and a fixed operation is planned...

The M7 Stationary is a cost effective option where mobility is not a requirement and a fixed operation is planned. It is recommended that a 100 litre electric pan mixer is used with this machine.

1 Compression Chamber

12 Months Machine Warranty

Free mould included in machine chamber

Training Available

±9 Operating Staff

Machine weight: ±800kg (excl. crating)

HYDRAFORM STANDARD 220MM INTERLOCKING BLOCK

This block is used to build load bearing walls using mortar in the super structure, by dry-stacking the blocks on each other in the wall. This block is used for all wall construction in housing and walling. This block will be perfect for ground + 1 construction.

HYDRAFORM STANDARD 180MM INTERLOCKING BLOCK

This 180mm wide, dry-stacking block is used in the construction of load bearing walls for single storey structures only. This block can be used on the first floor of double-storey structures, so as to reduce the weight, but cannot be used in the construction of the ground floor of a double storey structure. The 180mm block uses 20% less material than the 220mm block.

HYDRAFORM STANDARD 150MM INTERLOCKING BLOCK

This 150mm wide, dry-stacking block is used in the construction of non-load bearing walls for internal walls providing a ring beam is used. This block can be used in the construction of multi-storey structures as an in-fill wall panel between concrete pillars or steel columns. The 150mm block uses 30% less material than the 220mm block.

HYDRAFORM STANDARD 140MM SEMI-INTERLOCKING BLOCK

This 140mm wide block is semi dry-stacking, and a wet cement slurry is poured between the two vertical joints of the blocks. This block is used for internal wall construction and as an in-fill wall panel between concrete pillars or steel columns. The 140mm block uses 36% less material than the 220mm block.

HYDRAFORM LONG BLOCK FOR CORNER CONSTRUCTION

This block is made on any of the Standard Hydraform moulds by double filling the block compression chamber, if the material allows. The long block is used for corner construction and replaces the need for a half block. The daily production of long blocks must be 10% of the daily production of standard blocks.

HYDRAFORM CONDUIT 220MM INTERLOCKING BLOCK

This 220mm wide, dry-stacking block is used to lay the electrical conduit horizontally within the wall structure so that minimal wall chasing is required. This block can also be used in seismic areas (as per engineer’s design) to lay steel re-bar within the wall structure to strengthen the stucture but also allow enough flexibility to resist collapse during an earthquake.

HYDRAFORM CAPPING 220MM BLOCK

This 220mm wide, dry-stacking block is used for capping of boundary walls and for window sills.

The machine comes standard with a one mould option.

Enquiry Form


Related Products

If it looks right, it might not work right… the crippling cost of fake equipment.

We’ve all been faced with this situation before. You need equipment or a spares part, you’re a bit low on cash…and it becomes very tempting to take the easier, ‘cheaper’ route and get non-original parts. You save time, and money… right? Wrong!
Shopping Basket